In the past, manual processing of gypsum board was relatively complex. Since the advent of gypsum board machinery and equipment, the production process has been gradually simplified. It is mainly divided into the following steps. Let's have a look.

1. At first, operators should prepare materials, including gypsum powder, starch, accelerator, retarder and cement. Then, these raw materials should be transported to the mixer of the equipment through pipelines or pumps. After setting the time, Shandong gypsum board equipment will fully mix them until they are mixed into gypsum slurry.
2. After that, gypsum slurry will flow to the platform along the equipment, and then gradually form gypsum board through mixing, drying, heating, solidification and other steps. The molding equipment can meet the cutting requirements on the solidification belt. The gypsum board mechanical equipment manufacturer suggests that the operators should be careful when cutting.
3. After the successfully cut products pass through the drying area, they will be heated, dried and shaped by the hot gas on the gypsum board equipment, even if the products are finished.